这个好厉害哦，估计都可以找到了，那可以好好的折腾一下
我也想了解啊！升级变砖了。厂家升级软件了。这下麻烦大了。
chijiaoshenshi 发表于 2015-4-4 08:18
谢谢LZ分享，我也有个TL866CS，买之前没注意，要知道TL866A的ICSP功能一定一次性买了，结果现在后悔了，今 ...
那个编程器升级了没有？如果升级失败了，怎么解决？
我的饿砖了 不知道怎么弄好
还是多评论一点，下载不了，说我没有米
银子不够了
请用新版本V2.5，更新crc
http://www.diybcq.com/static/image/filetype/zip.gif TL866.zip (1.06 MB, 下载次数: 0)
1. Browse for update.dat file (any version is good including the new 6.80, 6.81 and 6.82)
2.Select the firmware dumper and click reflash.
3.After reflash click the advanced button
4.Now pay attention: if the copy protection checkbox is unchecked please check this and click write button.
If the copy protection checkbox is checked leave it alone.
This is important if you leave the copy protect bit unchecked then the new firmware will disable the bootmode, so beware!
5.Serial number and device code section.
Just click the write button in the serial number section. This will rewrite the same serial with the correct checksum.
This was a flaw in my reencrypted serial. A single byte checksum was wrong and the autoelectric discovered this after five years! good. I like this.
6.Close the advanced window, check the TL866A firmware and click reflash again.
强制进入bootmode方法
if the programmer is bricked. you can add a resistor(about 240 ohm) as the follow picture. and install old version software , then reflash firmware. then remove this resistor.
http://www.diybcq.com/data/attachment/forum/201901/22/215723t4toct0oo7rmrrjt.jpg.thumb.jpg
http://www.diybcq.com/data/attachment/forum/201902/11/175000rrmd20pww7lwz6z0.png.thumb.jpg
这个 固件可以改序列号不
xiaodaishu 发表于 2019-2-11 17:52
请用新版本V2.5，更新crc
TL866.zip (1.06 MB, 下载次数: 0)
1. Browse for update.dat file (any vers ...
刷回来了,但是读取固件都是错误的
没米 怎么办？