标题: Soldering station using inviot U1, an arduino compatible board [打印本页] 作者: liyf 时间: 2017-3-1 12:52 标题: Soldering station using inviot U1, an arduino compatible board
Soldering station using
. InvIoT U1an (Arduino compatible) board.
.
I am using the InvIoT U1 board to build a soldering station. There is a sensor with a wire connecting to the base of the soldering station with theInvIoT U1. That way I sense that the soldering iron is on the base, and if is sitting there for some time to drop the temperature.
Also if you haven’t used the soldering iron for some time (default 10min), it will shut the soldering iron down.
On the display there is a time clock. Everything is configurable through a menu.
There are 2 ways to build the circuit. Using a prototype board, or printing your own PCB. I have done it both ways, and I included all the pictures in the download file.
In the future I will print the PCB with OSHPARK.COM so you can order through them a PCB
One thing to consider is that from the 5 pin plug you will see 4 wires only. The middle wire is the ground , and the 4th wire is also the ground wire for the heat sensor . Please pay attention to the pictures.
In the download file you will find the schematic, PCB, and a lot of pictures of how to build it step by step.
1. Connect FTDI
2. Install latest version of Arduino IDE and the InvIoT library. Info on how to install can be found at InvIoT.com 'software setup'
3. On Arduino IDE go to File->Examples->InvIoT->g. Applications→soldering station
4. Edit the sketch to calibrate the temperature reading.
5. Press upload FYOE6UDIVCVTVXR.ino(14.6 KB, 下载次数: 0)
FYOE6UDIVCVTVXR.ino
(14.6 KB, 下载次数: 0)
howTo.zip