USB-FPGA Module 2.04
http://www.ztex.de/usb-fpga-2/usb-fpga-2.04.e.htmlFeatures
[*]USB 2.0 interface with Mini-USB connector (B-type)
[*]Cypress CY7C68013A EZ-USB FX2 Microcontroller (100 pin version)
[*]Xilinx Spartan 6 XC6SLX16 FPGA (XC6SLX9 and XC6SLX25 on request)
[*]External I/O connector (consisting in two female 2x32 pin headers with 2.54mm grid) provides:
[*]88 General Purpose I/O's (GPIO) connected to FPGA
[*]6 General Purpose I/O's (GPIO) connected to EZ-USB FX2 Controller
[*]6 Special I/O's (SIO) connected to EZ-USB FX2 Controller
[*]JTAG signals
[*]Reset signal
[*]External power (4.5 V .. 16 V) input
[*]3.3V output
[*]I/O voltage output or input, see External I/O connector
[*]64 MByte DDR SDRAM:
[*]200 MHz clock frequency
[*]16 Bit bus width
[*]Up to 800 MByte/s data rate
[*]Easy to use hard memory controller included Spartan 6 FPGA with 6 ports. (see SDK for examples)
[*]128 MBit on-board Flash memory
[*]Allows Bitstream loading from Flash to FPGA (up to 6.5 MByte/s)
[*]Accessible from EZ-USB FX2 and from FPGA
[*]128 Kbit EEPROM memory (can be used to store the EZ-USB firmware)
[*]2 Kbit MAC-EEPROM: contains a unique non erasable MAC-address and is used to store firmware settings
[*]On-Board power supply:
[*]3.3 V: 2000 mA
[*]2.5 V: 2000 mA
[*]1.2 V; 1000 mA
[*]Temperature range: 0-70°C
[*]
页:
[1]