nandpro3.0编程器

liyf · 发表于 2013-10-13 08:39:11

和2.0e电路差不多

===============================================================================
            SUPPORTED DEVICE INTERFACES
===============================================================================

USB:
LPC2148 Olimex USB header board.
High performance 16MB/2Mins.
LibUsb driver.

LPT:
Parallel Printer Port, SPP mode.
Low performance, 16MB/35mins (cpu dependant).
Dlportio printer port driver.

XSVF:
Subset device of USB.
LPC2148 Olimex USB header board required.
NOT for nand programming. This command line device type is for flashing
   .xsvf files to a Xilinx cpld.

POST:
Subset device of USB.
LPC2148 Olimex USB header board required.
NOT for nand programming. This command line device type is for monitoring
   Post codes only.

The included .hex file supports both Nand SPI flash, Xilinx Programming,
and Post Monitor all at the same time.
The mode selected ie: Nand Flash/Xsvf/PostMon is determined by the command line.
Previous .hex files as well as the "pic" version of hardware will not work.

The Maximus "NANDFlasher" has an array of plated through holes to break out all
the extra LPC2148 gpio. This product can be flashed with the new ArmV3.hex file
for full comatibility with Nandpro. The wiring coordinates are included here for
those who have this device. The included .jpg file shows the connections
to flash this device with the Philips utility. An RS232 level shifter is also
required for this purpose.

The Team Executor "NAND-X" can also be flashed with the ArmV3.hex, however the
wiring connections may be difficult, and are not listed in this document.

Nandpro30.rar (1.99 MB, 下载次数: 57)
gui界面

NandProGui_v0.1.zip (531.22 KB, 下载次数: 34)