EasyProg PIC Programmer

liyf · 发表于 2011-4-9 20:58:46

Supported PICsThe DIP package version (when available) for the following PICs can be programmed directly in the ZIF socket:

16F7x: 16F73, 16F74, 16F76, 16F77
16F84: 16F83, 16F84, 16F84A
16F8x: 16F87, 16F88
16F62x: 16F627, 16F627A, 16F628, 16F628A
16F64x: 16F648A
16F716: 16F716
16F7x7: 16F737, 16F747, 16F767, 16F777
16F81x: 16F818, 16F819
16F87x: 16F870, 16F871, 16F872, 16F873, 16F874, 16F876, 16F877
16F87xA: 16F873A, 16F874A, 16F876A, 16F877A
18Fxx2: 18F242, 18F252, 18F442, 18F452
18Fxx8: 18F248, 18F258, 18F448, 18F458
18Fx220: 18F1220, 18F2220, 18F4220
18Fx320: 18F1320, 18F2320, 18F4320
18Fxx20: 18F6520, 18F6620, 18F6720, 18F8520, 18F8620, 18F8720
18F6x8x, 18F8x8x: 18F6585, 18F6680, 18F8585, 18F8680
18Fxx25, 18Fxx21: 18F6525, 18F6621, 18F8525, 18F8621

The DIP package version (when available) for the following PICs can be programmed in the ZIF socket, but a modification must be made to the programmer first. To add support for these chips, connect pin 7 of the ZIF socket to pin 32. We recommend you permanently solder a wire between these two pins on the bottom of the board. Doing so will not disable support for any other PICs. All the PICs listed above can still be programmed by a modified programmer that has pins 7 and 32 of the ZIF socket connected.

18Fxx31: 18F2331, 18F2431, 18F4331, 18F4431

The DIP package version (when available) for the following PICs have a pinout supported by the ZIF socket. However, these PICs require a slightly lower Vpp programming voltage than the EasyProg produces. Although these PICs appear to work directly in the ZIF socket, we recommend a voltage divider be used on the Vpp pin. This can be done by using an adapter (not included) with the ZIF socket or by using the in circuit programming lines from the ICD OUT connector. For these PICs we recommend a voltage divider of 180 ohms in series with target Vpp pin, and 2Kohms from the target Vpp pin to ground.

16F88x: 16F883, 16F884, 16F886, 16F887
16F9xx: 16F913, 16F914, 16F916, 16F917, 16F946
18Fxx30: 18F1230, 18F1330, 18F1330-ICD
18Fxx23: 18F2423, 18F2523, 18F4423, 18F4523
18F2xx0, 18F2x21, 18F2xx5, 18F4xx0, 18F4x21, 18F4xx5: 18F2221, 18F2321, 18F2410, 18F2420, 18F2423, 18F2450, 18F2455, 18F2458, 18F2480, 18F2510, 18F2515, 18F2520, 18F2523, 18F2525, 18F2550, 18F2553, 18F2580, 18F2585, 18F2610, 18F2620, 18F2680, 18F2682, 18F2685, 18F4221, 18F4321, 18F4410, 18F4420, 18F4423, 18F4450, 18F4455, 18F4458, 18F4480, 18F4510, 18F4515, 18F4520, 18F4523, 18F4525, 18F4550, 18F4553, 18F4580, 18F4585, 18F4610, 18F4620, 18F4680, 18F4682, 18F4685
18F6x2x, 18F8x2x: 18F6527, 18F6622, 18F6627, 18F6722, 18F8527, 18F8622, 18F8627, 18F8722
18Fxx10, 18Fxx90: 18F6310, 18F6390, 18F6410, 18F6490, 18F8310, 18F8390, 18F8410, 18F8490

PICs that are supported in the current software but that have DIP packages with pinouts that required adapters (not included) for use in the ZIF socket are:

10F2xx: 10F200, 10F202, 10F204, 10F206
10F22x: 10F220, 10F222
12F5xx: 12F508, 12F509, 12F510
12F6xx: 12F629, 12F635, 12F675, 12F683
12F60x, 12F61x, 16F61x: 12F609, 12HV609, 12F615, 12HV615, 16F610, 16HV610, 16F616, 16HV616
16F5xx: 16F505, 16F506
16F6xx: 16F630, 16F631, 16F636, 16F639, 16F676, 16F677, 16F684, 16F685, 16F687, 16F688, 16F689, 16F690

这是原理图

prog7.pdf (436.68 KB, 下载次数: 23)
编程器软件

install_picprg.exe (2.92 MB, 下载次数: 23)

czc · 发表于 2017-1-20 18:57:40

谢谢分享。。

qishufa · 发表于 2017-1-19 13:55:04

eeeeeee

		自动登录	找回密码
密码			注册