|
|
比较古老的gal编程器，利用并口的，还在提供原理图和源代码，喜欢的研究下
动动板做的，作者布局挺整齐的
支持芯片
| Supported Device | Lattice Semiconductor Corp. GAL
GAL16V8A/B/C/D
GAL20V8A/B/C/D
GAL22V10B/C/D
Microchip PICmicro
PIC16C84
PIC16F84 | | Programming Specs | GAL: VEDIT = 15.0V, STR P/W = 40ms
PIC: Vpp = 13.5V | | Control Interface | IBM AT compatibles: Parallel Port
NEC PC9800: Printer Port | | Power Supply | DC7.5 to 15V, 100mA(max)
or a 6LR61(9V) battery | | Cost | $40 (parts) |
gal的结构图
原理图，不是很复杂
和并口的接线图
还可以用这个烧写pic芯片
bom列表
pgal_list1e.txt
(2.88 KB, 下载次数: 7)
pgal_list2e.txt
(3.08 KB, 下载次数: 4)
上位机程序
pgaltool.zip
(27.79 KB, 下载次数: 7)
，里面有源代码，汇编的哦
GAL assembler (16V8, 20V8 and 22V10)
fgal.zip
(31.62 KB, 下载次数: 6)
操作命令，英文的
Programming a GALConfirmed DevicesDeviceABCD
GAL16V8OKOKOKOK
GAL20V8?OK??
GAL22V10-OKOK?
PGAL <jedec file>
Run pgal.com with a JEDEC file, then a message that request to put a GAL device will displayed. Put a GAL on the socket and type any key, start to program. When the programming was finished with successful, remove the GAL from socket. A 20-pin GAL is put on the socket with adjust GND pin. RIght list shows the devices that confirmed to program.
Reading a GALPGAL /R
PGAL /R > <file>
Run pgal.com with /R switch and dislpays a GAL type selection menu. Select a required device, display a message that request to put a GAL. Put a GAL on the socket and then type any key, starts to reading, output fuse data and terminates program. Fuse map is output to console, so that please redirect to a file.
Erasing a GALPGAL /E
To erase a GAL, run pgal.com with /E switch. But GAL is erased before program so that this command is not used normaly.
Read and Write PICPICW84.COM is a control program for program to the PIC. Its usage is same as GAL programming. Hex-file format must be INHX8, and it must includes a configuration word.
|
|
雷达卡
发表于 2014-9-16 19:01:41
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
分享
支持
反对
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
发表于 2021-5-7 10:41:06
